We thoroughly clean your system and make sure its running at its max potential.
During this visit your service advisor tightened all electrical connections, verified all high voltage levels, verified all control voltage levels, tested all motors and compressor ( if applicable) to ensure amp draws are within proper range, and inspected all safeties for proper operation. We verified all start assists were within factory recommended range, inspected ductwork, and verified input and output levels on gas valve. We verified temperature difference across evaporator coil or heat exchanger, and visually inspected burners, and heat exchanger. We verified proper operation of auxiliary heat strips (if applicable). We inspected all fan wheels and blades for debris, cracks, balance, vacuumed out burner and blower compartment, and verified thermostat operation. We changed air filters if covered by the agreement, and cleaned up around equipment after the precision tune up was completed. We will also be checking all gas appliances to ensure that there are no carbon monoxide dangers at this time. We will check fire extinguishers, dryer vents, and test the batteries in all smoke detectors and carbon monoxide detectors. Your Service Advisor may have listed repair or system enhancement options for future reference that could potentially enhance your comfort, health & safety, extend the life of the equipment or help prevent excessively high utility bills.”
Out of sight, out of mind, right? Wrong...
During a PTU (Precision Tune Up) our Service Advisors will make sure your heating and cooling system will be cleaned inside and out. They will also clean any mess that is around your furnace in the attic or crawl space.
The crawl space floor and walls were covered 100% with 20 mil plastic encapsulation. Foundation vents were sealed, sump pump and dehumidifier were installed.